Tools & skills
Measuring · Fastening · Tool selection
Set up a bevel-down smoothing plane for clean shavings
Commission a sound Lie-Nielsen No. 4: hone the iron, fit the chipbreaker, adjust the mouth and test controlled smoothing cuts.
Start learning →
Sharpen a bench chisel with waterstones and a honing guide
Restore a dull, undamaged bevel-edge chisel, keep its back flat and test it on secured scrap wood.
Start learning →
Staple a fabric practice sample with a manual Arrow T50
Load a classic manual Arrow T50, fasten a thin fabric practice sample to thick softwood, inspect the result, and unload safely.
Start learning →
Set a small aluminium lap joint with a hand riveter
Make a small nonstructural aluminium lap joint by matching grip range, preparing clean holes and setting blind rivets squarely.
Start learning →
Check a manual box level and mark a short horizontal line
Repeat the horizontal reversal check on one footprint, then center the checked vial to draw and recheck a short wall reference.
Start learning →
Measure a practice bushing with a digital caliper
Check a matched ABS caliper, measure a removed bushing’s outside, bore and length, and record repeat readings without claiming calibration.
Start learning →
Glue up a flat three-board timber panel
Prepare and dry-fit the stock, spread compatible wood glue, balance clamps and cauls, allow a proper cure and inspect the completed panel blank.
Start learning →
Make a clean timber screw joint with pilots and countersinks
Build a two-screw face-joint sample while learning bit selection, clearance and pilot holes, shallow countersinks, clamping and controlled driving without splitting or stripping.
Start learning →
Measure, hand-crosscut and check a softwood blank
Lay out, hand-crosscut and check a 300 mm nonstructural softwood blank, keeping the saw kerf on the waste side.
Start learning →